Posted by cmsgtsmith on September 27, 2009, 4:16 pm
205.188.116.199

My drive belt for my Kazuma 800 has these numbers on it, 30.5X14X935Li. I believe that thes numbers are the metric size of the belt and I translate this to be 1.2 inches X.55 inches by 36.81 inches. The numbers seem to check out except the 935 mm measurement. Are these measurements for the belt and are they in millimeters. The original belt's outside measurement in inches is approximately 40.5. which is longer than the 935mm on the belt. Can you help me to understand these reading? would appreciate your assistance. Thanks, Ron.

 Post a Response

Posted by cmsgtsmith on September 30, 2009, 10:58 pm, in reply to "Drive Belts"
205.188.116.7

I assume every one is too busy or no one actually knows the answer to this one. Maybe I can get an answer from Kazuma although I doubt it. Does anyone know where all the guys that had all the answers have gone? Take care and have a great hunting season. (Even the dealer whom I bought the Kazuma 800 from doesn't know the answer to this one.)

 Post a Response

Posted by MAX on October 3, 2009, 9:48 pm, in reply to "Drive Belts"
24.212.75.225

The 935 maybe the inside measurement or (center measurement) like timing belts ??? MAX Sorry, if some time you don't understand what I'm talking about, I'M FRENCH... by the way, some time I don't understand what you say, it's probably because I'M FRENCH !!!

 Post a Response

Posted by sandyrun on October 4, 2009, 7:17 am, in reply to "Re: Drive Belts"
99.1.182.63

There is a list of replacement belts on this page. I replaced mine with a Polaris Ranger belt, a friend of mine replaced his with the gates belt from the list. The gates belt seems to be a better fit but either will work. You will need to have the belt drive properly set up if you want the best preformance form the machine. The instructions for doing this are in the tech. section of this web page as well. I hope this is some help. My belt was completly worn out and I had no numbers at all to go by.

 Post a Response

Posted by cmsgtsmith on October 4, 2009, 9:39 am, in reply to "Re: Drive Belts"
64.12.117.19

Thanks guys, I appreciate the information.

 Post a Response

Posted by JL242 on October 5, 2009, 5:07 pm, in reply to "Drive Belts"
205.188.116.77

I don't know about the numbers on the belt, but I do know that the factory belt will fray and cause you trouble. Make sure you get your clutches and belt set right. My factory belt frayed so much that the fray part went up into my starter and caused it to turn on and burn up. That was a costly problem, and of course Kazuma would not warranty it, although I would consider that a defect. If I were you I would get a belt through the Mammoth 800 site. Aaron knows his Mammoths.

 Post a Response