Posted by MAX you may also have a problem with the speedometer sensor... after the tranny get hot enough (130F), the sensor stop sending pulses and your speedometer will read (0)... most of 2009 had this bad sensor
Sorry, if some time you don't understand what I'm talking about, I'M FRENCH...
on August 29, 2009, 10:23 pm, in reply to "assembly instructions"
24.212.75.225 | Message modified by user MAX August 29, 2009, 10:32 pm
Welcome Aboard Woodypear !!!
I had the same problem... (Where do they go?) and I found they fit perfectly in the garbage can !!!
First I tough they was made for the CVT intake and exhaust tube, but they don't have the correct dimension. I have contacted my dealer and they have no idea on where to install them...
For the assembly instruction, you will find them at the bottom of the home page under TECHNICAL HELP SECTION
I strongly suggest you to read the forum and follow this list of (things to do)
-Flush all fluid (except brake fluid)
-Change air filter
-Check all electrical connection
-Change the screw in gas cap (or change the cap)
-Loctit the brake caliper bolts and adjust brake
-Recharge the battery
-Insulate the HV coil wire (To save it from rubbing to the distributor brace)
-Adjust the 4WD cable
-Adjust the transmission cable and selector switch
-Adjust engine idle RPM
-Adjust the timing on distributor
-Adjust / machine the secondary clutch
-Adjust / machine the primary clutch
-Change the belt for a Carlisle UA412 (Original belt is too short after the modification)
-Install washer between the starter and housing (Starter “click, click” a couple time)
-Install steering stopper (Hydraulic rubber hose ¾” long on each side) (To save the boots to get pinched)
and also check the coil bracket to see if it's just mine or it's a problem on every 2009 http://members7.boardhost.com/KazumaMammoth/msg/1246548767.html
Good luck !
MAX
by the way, some time I don't understand what you say, it's probably because I'M FRENCH !!! 
Message Thread:
« Back to thread