[ Post a Response | Galaxie Forum Full-size Ford, Lincoln, and Mercury ]
When posting a question about your Galaxie or other Ford (all are welcome), BE SURE to tell us what it is, what year, engine, etc so we have enough information to accurately answer questions.
Posted by Jay
on November 3, 2008, 5:36 pm
24.40.213.188
OK, I am already tired of sanding! 
Since I do not have a workspace of my own, I think I need to have the car blasted professionally so that the rust is properly treated. I will have the trim holes welded closed at the same time. Then etching primer, etc.
I have a few questions. Any advice along these lines is appreciated.
My first question - Should I have the car blasted and primed with the motor out of the car? That would make the most sense, right?
Second question - If I wait until the motor is back in the car, what precautions must I take when it comes time to media blast the car?
Third question - If the car is in the primer stage, how long can I wait until final painting? I need to save some money first.
Message Thread:
« Back to thread
